Abstract:
The mass flow rate from each injector nozzle hole of a diesel engine influences the distribution, atomization, and combustion of fuel in the chamber. Thus affecting the power, the fuel economy, and the emission quality of the diesel engine. A spray momentum flux test bench was built and used to measure the injection rate from each nozzle hole of a multi-hole nozzle in this study. Selected force sensors used for data acquisition were one of the integral parts of the set-up. The influence of the force sensors’ installed position (location in the set-up) on measured results, were analyzed and the optimum position that ensures independence of the results, determined. Additionally, the effects of injection pressure, injection pulse width and injection hole diameter on the injection characteristics were also investigated. Furthermore, in this research, the reliability and robustness of Strain sensor and Piezoelectric sensors were analyzed with regards to their response. The analysis showed that, strain sensors have weak dynamic response characteristic compared to piezoelectric sensors also, the measured result obtained from strain sensors fluctuated greatly. Piezoelectric force sensor gave a more reliable and stable measurement, comparatively. The accuracy of the results were affected by the installation position of the sensors. A distance of 16 mm (between nozzle hole exit and sensor surface) was determined to be adequate for the acquisition of reliable experimental data. As the injection pressure gets higher (during injection), the rate of mass flow increased, the average cycle-to-cycle variation coefficient and nozzle-to-nozzle variability coefficient of injection quantity decreased. Hence, improving the consistency of each cycle and the uniformity of each hole. In addition, increasing the injection pulse width decreased the average cycle-to-cycle variation coefficient. Also, nozzle-to-nozzle variability coefficient had minimal or no influence with regards to injection pressure. At 80 MPa, the uniformity of injection from the multi-hole nozzle improved significantly. In summary, the larger the hole diameters, the higher the maximum value of mass flow rate and the fuel injection quantity.
